| Opcode/Instruction | Op/En | 64/32-bit Mode | CPUID Fea-ture Flag | Description |
|---|---|---|---|---|
| F3 0F AE /0 RDFSBASE r32 | M | V/I | FSGSBASE | Load the 32-bit destination register with the FS base address. |
| F3 REX.W 0F AE /0 RDFSBASE r64 | M | V/I | FSGSBASE | Load the 64-bit destination register with the FS base address. |
| F3 0F AE /1 RDGSBASE r32 | M | V/I | FSGSBASE | Load the 32-bit destination register with the GS base address. |
| F3 REX.W 0F AE /1 RDGSBASE r64 | M | V/I | FSGSBASE | Load the 64-bit destination register with the GS base address. |
| Op/En | Operand 1 | Operand 2 | Operand 3 | Operand 4 |
|---|---|---|---|---|
| M | ModRM:r/m (w) | N/A | N/A | N/A |
Loads the general-purpose register indicated by the ModR/M:r/m field with the FS or GS segment base address.
The destination operand may be either a 32-bit or a 64-bit general-purpose register. The REX.W prefix indicates the operand size is 64 bits. If no REX.W prefix is used, the operand size is 32 bits; the upper 32 bits of the source base address (for FS or GS) are ignored and upper 32 bits of the destination register are cleared.
This instruction is supported only in 64-bit mode.
DEST := FS/GS segment base address;
None.
RDFSBASE unsigned int _readfsbase_u32(void );
RDFSBASE unsigned __int64 _readfsbase_u64(void );
RDGSBASE unsigned int _readgsbase_u32(void );
RDGSBASE unsigned __int64 _readgsbase_u64(void );
| #UD | The RDFSBASE and RDGSBASE instructions are not recognized in protected mode. |
| #UD | The RDFSBASE and RDGSBASE instructions are not recognized in real-address mode. |
| #UD | The RDFSBASE and RDGSBASE instructions are not recognized in virtual-8086 mode. |
| #UD | The RDFSBASE and RDGSBASE instructions are not recognized in compatibility mode. |
| #UD |
If the LOCK prefix is used. If CR4.FSGSBASE[bit 16] = 0. If CPUID.07H.0H:EBX.FSGSBASE[bit 0] = 0. |